Welcome to Warranty Killer Performance!
Usually ships within 24 hours
Easy to use
For oil and grease seals
Won't score surfaces
This tool is designed to help pull seals out with ease. Simply insert the tip of the tool behind the oil or grease seal, press and pull. Leverage works for you. Two size tips will reach in and fit nearly all the seal applications.
All years and models
We will notify you when this product becomes available.
Contact us for inventory
Lower starting gear ratio
Improved torque and throttle response
Lower belt temperatures
Longer belt life
The Rage 3P is an STM primary designed with the stock offset allowing it to be used with the stock secondary. To take full advantage of an optimal setup we suggest using the STM Tuner driven Can-Am long post along with the ...
Almost sold out
Single or Kit
Fast boot has a superior design combined with premium quality to provide a longer lasting CV boot. The Fast-Boot is made with solid premium quality CV Boot. It is easy to install and features premium quality rubber to minimize abrasion wear and provide a long service life. It can be...
Average 5 HP gain over OEM no tuning required
Increased throttle response
Unsurpassed in airflow, dirt stopping and overall performance
Fits in stock air box tighter than OEM filter
Traps dirt and dust in 2 layers of foam
The large pore, pre-filter captures the bigger particles
The small pore, inner filter prevents any engine-wrecking grit f...
The base tune files are the same for all modifications are as stated below then we taylor the calibration for specific modifications listed.
All torque limits are removed so whatever timing and fuel we calibrate to the unit it will make max power for that calibration and not hit any toque limits short of that under any conditions except if thes...
8620 Shaft & Gear Set
OEM 4 Link Wide
WKP 9 Link %225 Wider
Includes chain, shaft and gear
Lets face it the factory reverse chain was not designed for what we do with theses machines! No matter your riding style (trail, mud, sand or rock) this setup will allow you if you dare to go WTFO in reverse. Every kit comes complet...
SAVE! Buy direct from Polaris is $174.99/each vs our OEM at $67.99/each
Part #: 1205021Required Per Assembly: 1Application: All Polaris
Silicone rubber-like material for formed-in-place gaskets
Fills gaps on flange surfaces and seals joints with tough elastic film
Resists high temperatures when cured
Sets in 60 minutes
Gear and engine oil resistant
Yamabond 4 Motorsports is a silicone-based liquid gasket that fills gaps on a flange surface and prevents leaks. When cured, this...
Complete kit for cleaning and re-oiling of filters
Includes 5-1/2 oz. oil and 14-1/2 oz. cleaner
UNI Foam Filter Oil allows maximum airflow while keeping the dirt and dust particles out. UNI Filter Cleaner’s powerful agents quickly strip away grease and dirt, yet won’t damage air filters. Just spray it on, let it soa...
Performance upgrade item
Pistons 3D forged for lowest weight
Fully boxed and strutted for superior strength
DLC coated piston pin for reduced friction and heat
Made in USA 🇺🇸
Our piston is a performance upgrade item designed for racers. These pistons are 3D forged for lowest weight possible without sacrificing strength. Fully boxed and strut...
Preventative maintenance item
Includes bearing and both washers
Fits STM clutches
Our two way bearing service kit is a preventative maintenance kit designed to replace the two way bearing on the STM primary clutch - the correct way. The thrust washers on either side of the two way bearing should always be replaced when installing a new beari...